18

GE washer error code 18: combo unit pump filter clogged

Also shown as Error 18 pump filter on some GE models.

On a GE Profile UltraFast Combo washer/dryer, the code 18 means the pump filter needs to be cleaned. GE's fault code page says you may also see very wet loads at the end of a wash cycle, or dry times that are longer than before. The filter is there to catch small items that could clog the drain, and GE recommends cleaning it every 50 cycles or when the combo notifies you.

Quick answer: start with clean the pump filter. It takes 15 min and fixes the most common cause.

Signs you'll notice

What causes 18, most likely first

How to fix GE 18: free fixes first

Safety: unplug the washer before opening any panel.

1Clean the pump filter

15 min, medium. You'll need: towels, a shallow pan, a small flathead screwdriver or a coin

  1. Unplug the combo.
  2. Lay towels on the floor in front of the pump filter access door and keep a shallow pan handy.
  3. Use the screwdriver or coin to open the pump filter access door, as shown in GE's pump filter guide.
  4. Let the water drain slowly into the pan.
  5. Turn the filter and remove it.

Tip: Follow the Care and Cleaning, Pump Filter section of your owner's manual for the exact steps on your model.

Did this fix it?

2Clean and refit the filter

10 min, easy

  1. Rinse away lint, coins and other debris from the filter.
  2. Look into the filter housing for anything stuck and remove it.
  3. Refit the filter fully and close the access door.
Did this fix it?

3Check the drain hose and test

20 min, easy

  1. Make sure the drain hose is not kinked and is not pushed too far into the standpipe.
  2. Plug the combo back in and run a short cycle.
  3. Check that the code 18 is gone and that the load comes out less wet.
Did this fix it?

Still showing 18?

If code 18 returns right after you have cleaned the pump filter, the drain pump or the pressure sensor may be at fault. GE's page points to the filter, so call GE service rather than replace parts yourself. Make sure the code on your display is 18 and not 353, which uses a different procedure.

Find the part for your model

Match the part to the model number on the sticker inside the door or on the back.

How much does it cost to fix?

Do it yourself
$0
Replacement part
Drain pump or sensor: varies by model
Repair technician
Ask for a quote before the visit

Indicative only. Costs vary by model and region.

Questions people ask about GE 18

What does error 18 mean on a GE combo washer dryer?

GE says the pump filter needs to be cleaned. You may also see very wet loads or longer dry times.

How often should I clean the pump filter?

GE recommends cleaning the drain pump filter every 50 cycles or when your combo notifies you.

What tool opens the pump filter door?

GE's guide says to use a small flathead screwdriver or a coin to open the access door.

Why are my clothes still wet after cleaning the filter?

Check that the filter is fully refitted and the drain hose is not kinked. If code 18 returns, have GE service check the pump.

Is error 18 the same as 353?

No. GE lists 353 as a separate fault code with a different filter procedure. Confirm the code on your display first.

Related washer codes

Full guide: Washer won't drain · All GE washer codes

Sources: GE Appliances: UltraFast Combo fault and error codes, GE Appliances: Cleaning the pump filter. Reviewed 2026-10-07. WhatsMyErrorCode is not affiliated with GE.