E25

Bosch dishwasher error code E25: drain pump blocked or cover loose

Also shown as E6102 on some Bosch models.

Bosch dishwasher error code E25 means the drain pump is blocked, or the pump cover is loose or missing. The pump cover sits at the bottom of the tub, under the filter. Bosch's fix is to remove the filter, pop the cover off and clear out whatever is jamming the pump. Glass, bones, seeds and labels are typical culprits. Newer models may show the same fault as E6102 (or E61-02).

Quick answer: start with check the pump cover. It takes 10 min and fixes the most common cause.

Signs you'll notice

What causes E25, most likely first

Bottom of a dishwasher tub with the lower rack removed: a cylindrical filter twists out of the floor, with a flat mesh filter around it. Cylinder filter: twist to remove Flat mesh filter
The filter at the bottom of the tub, under the lower rack.

How to fix Bosch E25: free fixes first

Safety: unplug the dishwasher before opening any panel.

1Check the pump cover

10 min, easy. You'll need: a sponge

  1. Switch off the dishwasher's breaker before reaching into the tub.
  2. Take out the lower rack and soak up standing water with a sponge.
  3. Remove the filter. The pump cover is the small piece underneath it.
  4. If the cover is loose, press it down until it clicks, then refit the filter.
Did this fix it?

2Remove the cover and clear the pump

15 min, easy. You'll need: a spoon, a sponge, work gloves

  1. With the power still off, slide a spoon under the edge of the cover and pry until it clicks.
  2. Hold the cover, lift it until you feel resistance, then pull it forward to take it out.
  3. Remove debris and standing water from the pump area with a sponge. Wear gloves, as some debris may be sharp.
  4. Turn the impeller gently with a gloved finger to check it moves freely.
  5. Refit the cover until it clicks, then replace the filter.

Tip: Never run the dishwasher with the pump cover missing. Check your owner's manual if the cover looks different on your model.

Did this fix it?

3Reset and test

5 min, easy

  1. Switch the breaker off for about a minute, then back on.
  2. Run a short cycle with no dishes and listen at drain time.
Did this fix it?

Still showing E25?

If the pump is clear, the cover is secure and E25 keeps coming back, the drain pump may have failed. Bosch says to contact customer support if the problem persists. A technician can test and replace the pump.

Find the part for your model

Match the part to the model number on the sticker inside the door or on the back.

How much does it cost to fix?

Do it yourself
$0
Replacement part
Drain pump or pump cover: about $10 to $90
Repair technician
About $150 to $300 with labour

Indicative ranges, they vary by model and region.

Questions people ask about Bosch E25

How do I fix E25 on a Bosch dishwasher?

Turn off the power, remove the filter, pry off the pump cover with a spoon and clear any debris. Refit everything and run a test cycle.

Where is the drain pump cover on a Bosch dishwasher?

At the bottom of the tub, under the filter. Remove the filter and you will see a small cover over the pump opening.

How do I reset a Bosch dishwasher E25?

Clear the pump first. Then switch off the breaker for about a minute and run a short empty cycle.

Is E25 the same as E6102?

Yes. Some newer Bosch models use E6102, also written E61-02, for a blocked drain pump or loose cover.

Why does my Bosch dishwasher hum but not drain?

A hum with E25 often means something is stopping the pump impeller. Clearing the pump usually fixes it.

Do I need a new drain pump for E25?

Usually not. Most E25 cases are debris or a loose cover. Replace the pump only if the code returns after cleaning.

Related dishwasher codes

Full guide: Dishwasher won't drain · All Bosch dishwasher codes

Sources: Bosch US: Dishwasher error code E25, Bosch US: Dishwasher error codes. Reviewed 2026-10-10. WhatsMyErrorCode is not affiliated with Bosch.