Electrolux washer error code E10: water supply problem
Also shown as E11 C1 on some Electrolux models.
Electrolux washer error code E10 means a water supply problem: the washer isn't getting enough water to start the cycle. Electrolux lists it as the first code to check in its washer error guide, and it's usually something simple: a closed tap, a kinked inlet hose, or a clogged inlet filter. Electrolux dishwashers use a different code for a similar problem (i10), so check that you're reading the code on a washer.
Quick answer: start with open the tap and check the hose. It takes 5 min and fixes the most common cause.
Signs you'll notice
- The washer beeps and stops at the start of the cycle.
- The drum stays dry.
- Water trickles in very slowly.
What causes E10, most likely first
- Most commonTap closed or partly closed
Check both taps if your washer has two hoses.
- CommonKinked or squashed inlet hose
Usually behind the washer.
- CommonClogged inlet filter
Small mesh filters where the hose connects trap grit and scale.
- Less commonLow water pressure
If other taps nearby also run weakly.
- Less commonFaulty inlet valve
Water reaches the washer but the valve doesn't open.
How to fix Electrolux E10: free fixes first
Safety: unplug the washer before opening any panel.
1Open the tap and check the hose
- Open the water tap fully.
- Pull the washer forward and straighten any bend in the inlet hose.
2Clean the inlet filters
- Unplug the washer and close the tap.
- Unscrew the inlet hose from the back of the washer and from the tap.
- Clean the small mesh filter at each end (if present) with water and an old toothbrush.
- Reconnect the hose hand-tight, open the tap and check for leaks.
3Reset and test
- Unplug the washer for 1 minute, then plug it back in.
- Start a Rinse cycle and check that water comes in.
Still showing E10?
If the tap, hose and filters are fine and water pressure is good, the inlet valve has probably failed. Electrolux recommends contacting support if the code returns immediately after troubleshooting.
Find the part for your modelMatch the part to the model number on the sticker inside the door or on the back.
How much does it cost to fix?
- Do it yourself
- $0
- Replacement part
- Inlet valve: about $25 to $70
- Repair technician
- About $120 to $250 with labour
Indicative ranges, they vary by model and region.
Questions people ask about Electrolux E10
What does E10 mean on an Electrolux washer?
A water supply problem: not enough water is coming into the washer.
What's the difference between E10 and E11?
E10 points to the water supply itself. E11 usually means the washer started filling but didn't reach the right level in time.
Does an Electrolux dishwasher use E10 too?
Electrolux dishwashers usually show i10 for a water supply problem. E10 is the washer code.
Can I clear E10 myself?
Yes, in most cases: open the tap, straighten the hose, clean the filters, then reset the washer.
Related washer codes
Samsung 4CWasher: Not filling with waterSamsung OEWasher: Overflow / too much waterLG IEWasher: Water inlet errorLG FEWasher: Water overfillingLG PEWasher: Water level sensor errorBosch E17Washer: Water takes too long to fillFull guide: Washer not filling with water · All Electrolux washer codes
Sources: Electrolux UK: washing machine error codes. Reviewed 2026-10-07. WhatsMyErrorCode is not affiliated with Electrolux.